Anson Liu

I recently got a set of 10 Dahua IP eyeball cameras and 16 port PoE NVR.

My Colorado 3D Topographic Maps are used as supporting locator maps at the Mountains Majesty: On the Summit with John Fielder exhibit at the History Colorado Center in Denver, Colorado.

My maps and models continue to be available Printables.

You can add elevation contour lines and color changes to your 3D printed maps with a new script that I created.

Choosing a reliable start G-code that primes a dual extruder printer is difficult.

If your print fails due to an extruder error you can usually resume printing from the last successful layer if your print has not detached from the bed.

The default Creality start G-code for the K1 printer in Cura does not automatically set the correct extruder and bed temperature and you can change the start G-code to automatically set the right temperature for your material.

⚠️ This post comes with no warranty or liability.

Sometimes you just have to go off the rez (in a fun exploratory way).

A 1st generation (2005-2007) Ford Escape Hybrid with a “dead” 330V high voltage (HV) battery can be manually charged from wall outlet with the use of a 12V charger when the voltage has dropped extremely low.